The configuration utility (EPConfig) is only to configure or change the Enterpad codes. Once the codes are configured, the Enterpad will keep them in its memory. If the Enterpad codes were wiped, it is probably because the Enterpad was configured with an empty configuration file (a file with the “.pos” extension) instead of with the last configuration file you used. Does this make sense to you?
Enterpad with new computer
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
Enterpad with new computer - by Melb12 - 01-04-2019, 02:05 PM
RE: Enterpad with new computer - by denilama - 01-04-2019, 04:02 PM
RE: Enterpad with new computer - by Melb12 - 01-05-2019, 10:01 AM
RE: Enterpad with new computer - by denilama - 01-06-2019, 04:12 PM
RE: Enterpad with new computer - by Melb12 - 01-07-2019, 11:19 AM
RE: Enterpad with new computer - by denilama - 01-08-2019, 09:44 AM
RE: Enterpad with new computer - by Melb12 - 01-08-2019, 11:11 AM
RE: Enterpad with new computer - by MurrayMi - 10-07-2020, 02:56 PM
RE: Enterpad with new computer - by MurrayMi - 10-11-2020, 03:44 AM
RE: Enterpad with new computer - by denilama - 10-12-2020, 08:30 AM
|
Users browsing this thread: 1 Guest(s)